Factory Direct Generators Manufacturer Provides Best Budget Gas Diesel Generator Sets - Xinshengan

Gas generator cooling fluid not cycle is how to return a responsibility

by:Xinshengan     2021-01-05
Gas generator cooling fluid not cycle is how to return a responsibility: 1, the coolant level is too low, or do not conform to the rules. Liquid level is too low can directly cause the coolant temperature cooling fluid circulation, cooling fluid according to regulations is 50% antifreeze + 50% + DCA4 demineralized water, if do not conform to the rules will cause pipeline jam, rust inside the wall, make the cooling fluid can't normal cycle. 2, gas generating set pump failure. Check whether the water pump function is good, if it is found that the water pump drive gear shaft wear over time shows that the pump has does not work, need to change to normal cycle. 3, radiator fin jam or damage. A cooling fan doesn't work or heat sink jams, cannot make the cooling fluid temperature drop down, heat sink, rusty, leakage phenomenon can also cause a bad circulation. Section 4, probe is fault. Natural gas engine combustion chamber with a thermostat, the purpose is to control the engine combustion chamber temperature, thermostat must be within the prescribed temperature fully open help small cycle, if there is no thermostat, cooling fluid can't maintain cycle temperature, may lead to the low temperature alarm. 5, mixed with air in the cooling system, caused the uneven line, expansion tank on the suction valve and exhaust valve damage also directly affect the circulation, then should always check the pressure value is in accordance with the provisions, the suction pressure is 10 kpa, exhaust pressure is 40 kpa, exhaust line was clear except time also is the main reason that influence the cycle. More content: https://www gas generator. xsapower。 com/
Custom message
Chat Online
Chat Online
Chat Online inputting...